На какой высоте спускаемый аппарат начинает нагреваться?

Автор Dims, 21.11.2005 22:20:18

« назад - далее »

0 Пользователи и 1 гость просматривают эту тему.

X

Опираться будем на магнитное поле Земли.
Выпустим электропроводный трос.При прохождении
магнитного поля Земли в проводнике образуется
электроток.
Пускаем его на резистор-скорость падает-пошли вниз.


Или пусть нас с Земли тормозят чем-нибудь
 :?:

foogoo

ЦитироватьИли пусть нас с Земли тормозят чем-нибудь
 :?:

Есть и такое:

http://www.daviddarling.info/encyclopedia/L/laserprop.html
ЦитироватьPowerful lasers developed as part of the United States SDI (Strategic Defense Initiative) program have the potential to launch lightweight spacecraft into low Earth orbit. Tests have already been conducted, by Leik Myrabo of the Rensselaer Polytechnic Institute and other scientists from the United States Air Force and NASA, using a 10-kW infrared pulsing laser at the White Sands Missile Range and an acorn-shaped craft with a diameter of 12.2 cm and a mass of 50 gm. The base of the craft is sculpted to focus the beam from the laser on to a propellant. In tests so far, this propellant has been air, which is heated by the beam to a temperature of 10,000-30,000°C, expands violently, and pushes the craft upwards. A height of 71 m was achieved in an October 2000 trial. To orbit a 1-kg spacecraft will demand a much more powerful, one-megawatt laser and a supply of onboard propellant, such as hydrogen, to take over at altitudes where the air gets too thin.

Только рабочее тело в космос везти нужно в любом случае.

X

Цитировать... в проводнике образуется электроток.
Пускаем его на резистор-скорость падает-пошли вниз.

Тогда на резистор надо ТЗП ставить

X

Во сейчас только справочник полистаю...

Какой справочник-то листаем?